![xbox 360 nand x jrunner cr3 xbox 360 nand x jrunner cr3](https://demo.vdocuments.mx/img/378x509/reader024/reader/2020123110/55cf9d1e550346d033ac50f1/r-2.jpg)
The "Reads" selector to the left of "Read Nand" should be set to at least 2. You'll need to supply standby power to the console with the nand programmer attached in order to successfully read the nand. Within Jrunner this is just the "Read Nand" option in Jrunner. Solder them in according to the image, and then use the Jrunner software to read the nand. Solder in the nand reading/writing deviceĭefault assumption is that you're using a JR Programmer or a Nand-X, both devices were produced by Team-Xecuter and use the same cable and color coded wires to connect to the 360.Apply flux paste and pre-tin each of the areas that will have a wire soldered to them. Gently use a fiberglass scratch pen to remove the coating. Identify the J1D2 and J2B1 headers on the consoles motherboard
![xbox 360 nand x jrunner cr3 xbox 360 nand x jrunner cr3](https://m.media-amazon.com/images/I/611y0gSc1DL._AC_SY450_.jpg)
![xbox 360 nand x jrunner cr3 xbox 360 nand x jrunner cr3](https://m.media-amazon.com/images/I/51zAZ7e5uXL._SX342_.jpg)
The video tutorial that accompanies this written guide: Done - your console is now SMC Hacked aka JTAG'd.Write the updflash.bin file to the console.Use the CPU key in Jrunner to build a full hacked nand image (updflash.bin).Boot the console and obtain the CPU key from Xell.
#Xbox 360 nand x jrunner cr3 install#